rod milling

In the process of high speed wire-rod milling, micro-tension and automatic loop control are usually used, to assure the precision of wire sectional size, and to increase the productivity and the wire quality.

在高速线材生产中，大都采用微张力和自动活套控制，以保证轧材断面尺寸精度，提高生产效率和产品质量。

Firstly the variable cutting parameters of spiral rod milling are analyzed to extract the eigenvalue of vibration and power signals. Then the mapping between the signal eigenvalue and the tool wear value is established.

该方法针对螺杆加工中变切削参数的工况，提取了振动信号和功率信号的刀具磨损特征值，并建立了信号特征值与刀具磨损量之间的映射关系，从而得到刀具磨损模型。

With the emerging of the complex component and difficult processing materials, people hope that can use simple electrodes ( for example, rod-electrodes) as the same milling cutter for the conventional forming EDM.

但随着复杂构件和难加工材料的不断出现，由于传统的机械加工方法在这方面的加工有局限，人们非常希望能用简单电极（如棒状电极）像铣刀一样进行电火花成形加工。

Tool Wear Modeling on Special Spiral Rod Milling Based on Power Signal

基于功率信号的异形螺杆加工刀具磨损建模

Tool wear modeling method for spiral rod milling is presented.

介绍了一种螺杆铣削过程刀具磨损建模的方法.